Interactive User Guide
NEXIS /6000 Pro Hydrogen Water Bottle
A quick mobile-friendly guide for first use, safe operation, cleaning, and support. For advanced diagnosis and detailed questions, use the official Ocemida interactive troubleshooting and FAQ pages.
Quick guide
Setup checklist, soak timer, cycle selector, cleaning guide, and self-help links.
Purified, reverse osmosis, or distilled water helps protect the membrane.
Fill to the max line or lower, about 280 ml. The inside cap hole must stay above the water.
Avoid fast chargers, computer USB ports, and public charging stations.
No dishwasher. Do not submerge the generator or wash the membrane with soap.
Official guided support
Interactive Troubleshooting
Best for leaks, charging problems, power issues, unusual bubbles, and cases where a video or photo may be needed.
Complete help center
Interactive FAQ
Best for detailed product questions, water type, cleaning, usage, warranty, safety, and general hydrogen water questions.
First time use
Initial membrane activation
The PEM membrane ships moist and should remain moist. Keep the plug for travel or long storage.
Setup checklist
0 of 6 complete
1-hour vinegar soak timer
Do not turn on the device during vinegar or cleaning solution soaking.
Daily operation
Operate safely
- Fill with purified water to the max line or lower.
- Close the cap and confirm the water does not cover the inside cap hole.
- Press the power button once for a 5-minute cycle. Press again to switch to 10 minutes.
- For a 15-minute result, run 10 minutes, open the cap to release pressure, then run 5 minutes.
Cycle selector
Choose a cycle to see the expected hydrogen concentration.
Good daily quick cycle.
Regular maintenance
Keep the generator clean without damaging the membrane
Soap or harsh cleaning agents can damage the membrane. Use pure water or vinegar on the membrane, and use a cotton swab or pad only for the threads.
Maintenance schedule
Rinse all parts with warm water after use.
Use white vinegar or Ocemida cleaning solution. Do not turn on the device during soaking.
Tap the cap on a towel with holes facing down to remove trapped water.
Use the membrane plug to help keep the membrane moist and protected.
Remove the membrane plug. Add about 100 ml, or 3 oz, of cleaning solution or white distilled vinegar. Let it sit for 30 minutes, then rinse with warm water.
Self help
Troubleshooting helper
Use this quick manual-based self-check for common issues. For the full guided workflow, open the official interactive troubleshooter.
Frequently asked questions
Quick manual FAQ
This section includes the most important questions from the printed guide. For the comprehensive interactive FAQ, use the official Ocemida FAQ page.
Need help?
Contact Ocemida support
For leaks, charging codes, or visible damage, stop using the device and send a short video or photo from above. This helps support diagnose the issue faster.
Water level and pressure valve
The water should not cover the small hole inside the cap because this is where the pressure release valve is located. Fill below the max line, about 280 ml or 1.2 cups. After washing the cap, tap it on a towel with the holes facing down to remove trapped water.
